About Solid Lube Use

DIY:

Fill the bottle containing the solid lubricant with water (around 180ml) to full, shake it for 2 minutes and place still for 60 minutes.

Direction:

1.Shake the bottle for 10 seconds with fast speed

2.Open the lid on top

3.Place the melted lubricant for use

Note:

1.Fill in water a day before use for better effect.

2.Follow the direction above for more lubricant when it dries out.

Male Stroker Clean

Step 1 Rinse the residual liquid
Please use the neutral cleaner after foaming into the cup, mix with the residual fluid and lubricant in the cup, and then rinse with water.

*Neutral detergent.

Bathing gel, hand soap, dish soap and other non-alkaline or acidic cleaners, simply put, can be used to wash your body or hands. (Soap is not recommended, because most soap is weak alkaline, may cause silicone deterioration, brittle)

Step 2 clean again
The same steps as above, add the detergent after foaming, fingertips gently after the internal structure of the cup, dead ends, clean with water.


*Fingertip.

Finger belly in the gel when gently scrubbing, not too vigorous, in order to clean off the residual body fluid mainly. Then... Cut your nails, cut your nails, cut your nails! Do not use your nails to scrape the gel, only your fingertips! If you scratch the gel is easy to breed bacteria, card dirt!

Step 3 shake the water
After rinsing, make sure there is no body fluid or lubricant left in the cup, then hold the cup upside down and gently break the hole to shake out a lot of water.

Step 4 Wipe off the residual water
Use a kitchen towel or a wand to wipe up the residual water in the cup.

Step 5 Powder maintenance
Use the powder to puff on the outside of the cup, so that the outside of the cup will not be greasy and easy to store without burden.

*Note.

When sprinkling the powder, please sprinkle a small amount on the outside of the cup, use your fingertips to gently apply the powder evenly to cover the outside of the gel (powder to cover the gel is good, not too much, too thick).